BMW Automobile Accessories R50 User Manual

Page 1 of 5  
Installation Instructions  
November 2004  
Audio, iPod Interface  
Ver 1.0  
Accessory  
Development  
SUBJECT  
iPod® Interface Kit – P/N 65 11 0 392 139  
MODEL  
MINI Cooper (R50):  
Select Vehicle Production 03/02 – On*  
Select Vehicle Production 03/02 – On*  
Select Vehicle Production 09/04 – On*  
MINI Cooper-S (R53):  
MINI Convertible (R52):  
* Not compatible with 6-Disc CD Changer (SA672), Sirius Satellite Radio, or Hands-Free Phone System.  
SUGGESTED INSTALLATION TIME:  
0.5 Hours  
The instructions below are developed for MINI vehicles and are not be compared to any other existing  
instructions for vehicles other than MINI. No methods other than those specified in this document are to be used  
for installation in MINI vehicles. Left and right are determined from driver’s seat.  
Carefully read all instructions and supplements before proceeding with the installation. Reference should be  
made to TIS for instructions dealing with a stock part of the vehicle but not stated in detail in these instructions.  
The instructions were complete and up to date at time of publication; however, changes to the vehicle or  
installation may have occurred. Please report any problems or changes noted with the installation to BMW  
Technical Hotline, along with VIN, date of manufacture and as much detail as possible.  
PARTS INFORMATION  
Contents of Kit – P/N 65 11 0 392 139  
Description  
iPod Adapter  
iPod I/F cable  
Radio I/F cable  
Rubber Grommet  
Owner's Manual  
QTY  
MINI Part Number  
65 11 0 392 138  
65 11 0 393 656  
65 11 0 392 142  
N/A  
1
1
1
1
1
65 11 0 392 140  
SPECIAL TOOLS  
Pin Removal Tool – 61 1 134  
Crimp Tool – 408 449  
 DO IT RIGHT THE FIRST TIME, ON TIME, EVERY TIME    
Installation Instruction P/N 01 29 0 393 657  
MINI, a division of BMW of North America, LLC  
© 2004 BMW of North America, LLC  
 
3
8. Insert 4 rectangular pins from iPod harness  
(1) into radio harness (2) as follows:  
Color  
Location Description  
White/gray  
Brown  
Violet/white  
Red/green  
9
12  
16  
15  
I-Bus  
Ground  
KL-R  
KL-30  
9. Remove white 12-pin connector (3) from  
lower section of radio connector.  
10. Insert white 12-pin connector (1) from iPod  
harness (2) into lower left section of radio  
connector (3).  
11. The white 12-pin connector (4) removed from  
the factory radio connector in Step 9 will not  
be re-used for this installation.  
12. Connect 4-pin connectors (1 & 2)  
13. Locate and drill 5/8” (16mm) hole in glovebox.  
A = 1” (25mm)  
B = 1” (25mm)  
C = 5/8”(16mm) Ø  
Installation Manual P/N 01 29 0 393 657  
 
4
14. Insert iPod cable (1) through hole in glovebox  
as indicated.  
Note: Split grommet as shown before placing  
around iPod cable in order to prevent damage  
to cable.  
15. Split grommet (1) as indicated (2) and insert  
grommet through hole in glovebox wall.  
16. The flat iPod connector (1) should be located  
in the glovebox and the 8-pin DIN connector  
(2) for the adapter box should be routed  
through the center console to a location  
behind the radio.  
17. Re-connect glovebox vent tube.  
18. Re-install glovebox.  
Caution: Check for bent pins on adapter  
cables before attaching to iPod adapter. If  
pins are damaged carefully bend them back  
into position with a small screwdriver.  
19. Slide iPod adaptor fully into foam padding  
tube (1).  
20. Connect white “iPod” adapter cable (2) and  
black “Radio” adapter cable (3) to iPod  
adapter, making sure to connect cables in  
their proper location.  
Installation Manual P/N 01 29 0 393 657  
 
5
21. Mount iPod interface as indicated below radio  
and secure with cable ties(not included).  
22. Re-install all components removed for  
installation procedure.  
VEHICLE CODING  
There is no vehicle coding required for this installation.  
TROUBLESHOOTING  
iPod mode is not selectable from the radio until an iPod is connected.  
(refer to MINI iPod Interface Owner’s Manual)  
This iPod Interface is compatible with the following software versions:  
o Gen3 iPod – SW 2.2 or newer  
o Gen4 iPod - SW 3.0 or newer  
o iPod mini – SW 1.1 or newer  
If the customer’s iPod or iPod mini has older versions of software, please advise  
them to upgrade the software before connecting them to the Interface in their  
MINI vehicles. (refer to MINI iPod Interface Owner’s Manual)  
Installation Manual P/N 01 29 0 393 657  
 

BenQ Computer Monitor 9HL8PLBQPA User Manual
Blue Rhino Patio Heater EWT700SP User Manual
Briggs Stratton Pressure Washer 195764GS User Manual
Campbell Hausfeld Staple Gun IN729300AV User Manual
Casio Cash Register TE 2200 User Manual
Chamberlain Automobile Electronics 940CD 01 User Manual
Char Broil Electric Grill 08601559 16 User Manual
Chicago Electric Work Light 95573 User Manual
Chief Manufacturing Indoor Furnishings PTS Series User Manual
Cisco Systems Network Card Cisco AS5350 User Manual